ARM DEVELOPMENT BOARD
LPC 2148 BASED
Specifications of Board:
- Use 16/32 Bit ARM7TDMI-S MCU No.LPC2148 from Philips (NXP)
- Has 512KB Flash Memory and 40KB Static RAM internal MCU
- Use 12.00MHz Crystal, so MCU can process data with the maximum high speed at 60MHz when using it with Phase-Locked
- Has RTC Circuit (Real Time Clock) with 32.768 KHz XTAL and Battery Backup.
- Support In-System Programming (ISP) and In-Application Programming (IAP)
- through On-Chip Boot-Loader Software via Port UART-0 (RS232)
- Has circuit to connect with standard 20 Pin JTAG ARM for Real Time Debugging
- 7-12V AC/DC Power Supply.
- Has standard 2.0 USB as Full Speed inside (USB Function has 32 End Point)
- Has Circuit to connect with Dot-Matrix LCD with circuit to adjust its contrast by using 16 PIN Connector.
- Has RS232 Communication Circuit by using 2 Channel.
- Has SD/MMC card connector circuit by using SSP.
- Has EEPROM interface using I2C.
- Has PS2 keyboard interface.
- LCD Display Interfaced
- VGA Aocket Interfaced
- All port pins are extracted externally for further interfaces.Figure displays